On Tuesday, November 27, 2012 1:25:42 PM UTC-8, David Reitter wrote:
I have switched my club and also my own glider to Anderson PowerPoles for power.



No issues with male/female connectors (unlike XLR). One criticism would be that they do not have strain relief on the cable insulation. But that's not been a practical issue. The other would be that they do not screw together to secure the connection (some aviation-grade connectors do), but that also makes is easier to connect/disconnect. So, practically, not a problem.

Anderson make clips that go over the PowerPole connectors to secure them in place. Its usually more hassle than its worth, although I think I heard of one pilot disconnected the battery when reaching over their shoulder and pulling stuff off the shelf. Common sense I guess, you need to protect that connection in some way, have it where it can't get unplugged.

If you are using PowerPoles please get a proper ratcheting crimper for them.. Quite often I've seen bad crimp jobs on these, either the crimps are not properly made onto the wire or the improper crimper deforms the connector (either that or the user bending the deformed connector back so it fits into the socket) in a way that the mated pressure on the contact blades is less than it should be and the connection more likely to undo or be less reliable. Cheap non-ratcheting crimpers cannot supply sufficient force to swage the connector onto wiring--the wire strands and connector will effectively fuse together with the metals swaged under such high pressure. One comparison of good/bad crimps is here http://www.etco.com/crimp-photo-gallery. You should also hopefully be using a high quality Tefzel insulated aviation wire with silver plated strands to help prevent corrosion (properly crimping that type of silver plated stranded wire into a silver plated connector as in the case of the PowerPoles connectors works just great). Resist the temptation to solder and/or crimp then solder a crimp connector, just not a good idea.

The genuine Anderson PowerPole crimper is expensive but probably well worth if for a club, repair shop or group of owners. http://www.powerwerx.com/crimping-to...powerpole.html

Some folks might be confused between XLR (aka Cannon) connectors and DIN connectors. Not sure, neither would be my preference. DIN can be fragile and XLR are just large and klunky. And cheap versions of both connectors can have corrosion problems.

Darryl