On Thursday, February 6, 2014 2:49:37 PM UTC-6, J. Nieuwenhuize wrote:
Giving up things like automatic connections would be down right stupid. What I'm proposing is something like the V2/ASG29.

So, how big a span on that center section are you proposing? Roughly the same as the inner sections on a V2C/ASG29 assembled? That would be one pretty heavy wing section!

Once you move the wing up to a pylon and join the inner halves, there's a
large reduction in parts. 4 less half root ribs, 2 less shear web fillers, 4 less spar bolt inserts, 2 controls less (only one for flap, one for
spoilers), one spoiler less, two push-pull tubes for the spoilers less, more room for a mixer and on and on.

So, you are proposing a single spoiler panel that extends a couple of feet either side of centerline? Keep in mind that the flaps move as ailerons on those planes, so if you go to one flap pushrod going into the center section, you will force the aileron mixers into the wing. And since you are doing that, you might as well just go with one aileron input into the center wing. That is how many three piece wing ships do it. As to the reduction in number of parts, you will have the ability to use fewer pushrods, but I am not so sure you will be able to do away with all the ribs and things to attach the wing to the fuselage (pins in the root ribs and spar bolt inserts are now replaced with fittings to attach the center section to the pylon, ribs for control bellcranks, etc). And if I am understanding your location for the spoiler, you are going to lose a LOT of room where those connections are going on.


One of the more interesting features of a pylon wing is in fact it's
(potential for) practicality. Do away with the one-men rigging aids and put a spring-loaded joint on the pylon. Pull the middle wing from the trailer while the other tip is still in it's dolly, cant horizontal and put it on the
spring-loaded receptor. No need to have a one-man rigging aid if your glider has it built-in. Vary required tip lifting by moving the wing dolly inboard a bit.

You lost me on the spring loaded joint on the pylon. Also, depending on how long the center wing panel is, you may have to roll the fuselage a LOT further back so that when you get the center section out so the far tip is at the back of the trailer, the middle of it is now along side the pylon. And, since you have a pylon sticking up above the fuselage, you will now have to lift that center wing panel 5-6 feet into the air to get it over the fuselage.

The interesting thing about the pylon-mounted wing is that nobody I discussed it with (including some involved in last-generation factory ships) actually
disliked the idea that it had potential in the end. Especially for monocoque wings (like the Diana), there's a lot to be gained.

There have been many advances in understanding aerodynamics since that experimental Std Cirrus with the pylon mounted wing. Maybe there is a performance benefit to be had? But with the biggest emphasis seeming to be reduction of the wetted area for whatever class is being worked, I am doubtful that adding the wetted area of a pylon of the required height to reduce the wing root interference drag is the road to performance improvements.

Just my thoughts.

Steve Leonard