View Single Post
  #4  
Old October 26th 14, 01:20 PM posted to rec.aviation.soaring
Cookie
external usenet poster
 
Posts: 152
Default Recognizing and reacting to tow plane engine failure

Its all "communication"..

But the whole point of the "turn" signal is that the tow pilot doesn't need to or try to "fight" it.

So which signals do you use radio for and which signals do you use the standard accepted signal?

Do you brief glider pilots as to which signals you do not respond to and which you do?

Has the SSA changed/adopted the accepted signal for "tow plane please turn" to now a "radio signal"?

When the tow plane rudder hits the stop, what happens? It snap rolls!!!??

Cookie





On Sunday, October 26, 2014 6:48:57 AM UTC-4, Bruce Hoult wrote:
On 2014-10-26 09:45:47 +0000, Cookie said:

Ok...and signalling a turn by moving out to the side will not make the
towplane hit its rudder stops either ...so what's the problem?


Shall we now replace all 17 of the "standard American soaring
signals"...with "use radio"?

Cookie


If boxing the wake causes the towplane to reach control stops then you
are doing it WAY WRONG and should expect to wear the rope, yes.


If it's mere communication ... like wagging your wings ... that's one
thing. If it's physically pulling the tail around against the tow pllot
attempting to maintain his intended heading then that's quite another.