On Tuesday, 4 August 2015 05:15:06 UTC+3, wrote:
krasw, where do you set your ISU% ? at Richard's (Craggy Aero) suggestion I have mine set at 50%. I am not even certain I know what adjusting the ISU percentage actually does. Anyone that has an opinion on that subject pleas jump in here.
I have Butterflies in both seats of my ASH25 and will assign the co pilot the job of mapping thermal probability using instant wind variation, Perhaps you have discovered a secret weapon.
Dale

I have used vario/inertial mix between 75-85%. I think you loose a bit of inertial data with 50% mix, though ISU installation "quality" might affect optimum mix. My ISU is in very good place at rear fuselage (yes it was pain to install), it gives sensible readings even at 100% mix.

My vario time constant is slow 3,4 sec and inertial netto time constant fast 1 sec to get instant readout of vertical gusts (helpful when thermalling).. Wind calculation time constant is 5 sec.

Following wind variations during flight really takes time and learning (mainly to start build mental 3D image of the airflow around you). No proper instrument existed before to measure it this fast and reliably.