On Friday, January 29, 2016 at 3:45:08 AM UTC-8, Neil McLaughlin wrote:
I out the software update on the micro SD, and that automatically
updated, i then went to hardware and reregistered the stick.

Just looked at the manual, didnt take those steps with the firmware
update- will give it a try tomorrow!


At 03:59 28 January 2016, ZP wrote:
Did you go to the password page and force the update through there?
Rebooting the S80 with just the files is not enough. Check the
instructions. If you did all that, maybe try again. Could have had a
corrupted load(?).


Neil,

Two processors have firmware updates.

The first processor in the S80 updates automatically. The second processor you have to go to the password screen enter 89891 and select the firmware and update.



Richard
www.craggyaero.com