On Tuesday, June 6, 2017 at 8:47:08 AM UTC-4, wrote:
Do all the previous updates need to be put into the portable FLARM too? My unit shows 6.09 on startup, but only shows transponders, no FLARM targets. I may have taken it back to zero updates while trying to get 6.09 in. I hate this digital crap!
JJ

If 6.09 shows, you should be good. Did you re-install your flarmcfg.txt file after the firmware update? Something may have gone astray when the old one was replaced.

The other possibility, since pcas/transponders show and flarm doesn't, is that your flarm antenna may have a problem. I'd unscrew and screw it back in and see if that works.

Cheers

Dan