Here's my experience with Anodizing. I liked it a lot.
http://www.eaa292.org/noon_patrol/dec_00/p1010006.jpg

Richard Riley wrote:

I've just finished machining my instrument panel. It is (I say with
no small pride) nice. Milled out of 2024T3 3" thick, reduced to .120
with .120 webs between each instrument and around the perimeter.

Now the question is: how should it be finished? Polished? Engine
turned? Anodized? Clear powder coat?

--
John Kimmel


I think it will be quiet around here now. So long.