View Single Post
  #4  
Old March 3rd 07, 04:44 AM posted to rec.aviation.soaring
BT
external usenet poster
 
Posts: 995
Default Trailer tow vehicle fuel pumps

I have never had to replace a fuel pump... "knocking on the gas can"...
and I hope I never do.

BT

"Bill Daniels" bildan@comcast-dot-net wrote in message
. ..
As there seems to be a lot of interest in X/C, landouts and retrieves,
possibly from remote areas, let me bring up a problem area - crappy
electric fuel pumps.
Most vehicles these days are fuel injected with an electric fuel pump in
the tank. These electric pumps, according to an informal survey of
friends and acquaintances, fail with alarming frequency - usually within
~50K miles and each 50K thereafter. Failure will always occur without
warning and in the worst possible place and at the worst possible time.

According to my last tow truck driver, these crappy pumps provide him with
a nice business - he estimates 50% of his tows are failed pumps. The more
expensive the car, the more likely he is to tow it. The tow truck won't
tow your glider - just the car. This probably means leaving the trailer
on the roadside until you can come back for it. Not good.

A pump failure will cause instant engine stoppage and loss of power brakes
and steering. This means wrestling the car and glider trailer to the
roadside. Once you are on the roadside, you will find that no matter how
good you may be at fixing cars, there is nothing you can do but call a tow
truck since pump replacement requires a high bay hoist where the gas tank
can be removed. It just isn't a DIY job.

One popular solution among off-roaders is to replace the in-tank pump with
an external, in-line pump that CAN be replaced on the roadside. In fact,
I'm considering two pumps in parallel with check valves and an A/B switch
in the cab. I could then just flip the switch and be on my way. I'd
replace the failed pump at my convenience.

The downside of in-line pumps is they are noisy - at least they can be
heard operating in an otherwise quiet vehicle. Some soundproofing around
the pump can take care of this.



Bill Daniels