X-change Dittel for Becker
I've never seen such a thing, but it might not be too much work to
simply remove the panel, remove all of the switches and instruments, and
plug the square hole with fiberglass or carbon.Â* Then cut a new round
hole and remount the things you removed.Â* Except for the cure time on
the resin, it should be less than a day's work.
Good luck!
Dan
5J
On 6/10/21 9:31 AM, Phoenix wrote:
I currently have a Dittel mounted at the bottom of the stack. I would like to replace it with a Becker. Is there an "adaptor" to change the mounting hole from the square Dittel to the round Becker?
|