As to your snap roll observation... in level schnapps do you start with
full power? It takes more pull and g's to snap with full power, as you
would in a climbing line, than it does with reduced power. I know myself
that I keep to 120 mph or less in a level or diving snap,
I, too, try to keep level or down snaps at 120 or below, and whatever power it
takes, depending on what came before.If the snap follows a half loop up or some
other speed-losing stunt, I just leave the throttle open till I get my 120.
Unless, of course, it's a combination with, say, a half loop up with half snap
attached. If following, say, a push 5/8 loop as in this year's Advanced known,
I reduce power on the 45 down to make the line before the snap a bit longer, so
I can lengthen the line after for more speed out. There's a difference between
constant speed and fixed pitch prop, too. With the CS prop, the gyro is always
at full speed, whereas with a fixed pitch, it varies.
You're right about the barrel roll and the altitude loss if trying to maintain
approx. 1g. I think that the most customer-friendly roll starts out as a barrel
roll, but with an increased roll rate at the highest point of the arc, and
going to about 1/2 g when inverted. Or even 1/4 g, just enough positive so
they're not hanging on the belts.
I've been told that a "military" barrel roll, as taught to guys like my dad who
took PT in Stearmans, by definition has a 90 degree heading change at, shall we
call it, the apogee. Finishes on original heading, of course. I taught myself
these...they are very fun, but can't stay below about 3 g's in the Pitts. Then
I went out and demo'd them to a friend in his stock 220 Stearman. Those were
REALLY fun! A plane that actually uses wings flys so much differently...
Doug
|