The standard ball works fine if....

Most standard balls have flat sides so they can be gripped by a wrench while
the nut on the bottom is being tightened. Carefully mark where these flats
lie on the hitch, and have two small bars welded onto the hitch. This will
keep the ball from turning.


On 6/16/05 7:57 PM, in article Nlose.222$SF5.199@fed1read07, "Greg Arnold"
wrote:

Gary Evans wrote:
I finally installed an Alko AKS 1300 (shown at the
same web site) on my Toyota 4 Runner and Cobra (DG808)
after trying everything else short of relocating the
axle and it worked. Expensive but much less trouble
than reworking the trailer.

I presume the standard ball won't work, because this device would slowly
unscrew it?


--
Bob
bobgreenblattATmsnDOTcom --fix this before responding