It's a paper washer. It was new.

Today I found that the bolt flanges were cracked. Fortunately, a fellow TP
owner has installed the soin on filter on his and had his cover.

mike regish

"Bill Hale" wrote in message
om...
"mike regish" wrote in message
news:Dj3Bc.81904$Sw.45236@attbi_s51...


Does the oil screen have a crush washer?

Did you use a new one? Bill Hale


Did an oil change on my Tripacer. I've done them before and they're
pretty
easy. This one though, it looks like my oil screen cover is leaking like
crazy.

I actually changed the oil last month right before it went into annual.
They
flew it (looks like a couple of hours worth) with no leaks apparent. I
flew
it for the first time last week and when I was parked to gas up noticed
oil
dripping. Went up today and checked the torque on the oil screen housing
and
they were all tight. Came back after 20 minutes or so and found I had
left a
trail of oil. Lost a good part of a quart. I'm thinking I may not have
torqued them down evenly and I'm going to try replacing the gasket and
going
around the bolts a little at a time. I usually retorque them after I run
for
a while after an oil change because the gasket tends to crush some.

Any ides or suggestions on why this is happening? The surfaces are
(were)
clean. I'll check better when I replace the gasket.

TIA.

mike regish
'53 Tripacer