At 15:09 13 February 2020, soaringjac A four inch dia hole should
suffice for access. Is not a big deal. Done that before.
On Thursday, February 13, 2020 at 2:59:36 AM UTC-8, krasw
wrote:
Just pull the adapter (with tube attached) out of the fin
leading edge
an=
d install new one:
=20
https://www.esa-systems.com/en/produ...ails/mounting-
adapter-st1r-6-m=
m/
=20
Should be possible with little effort, the adapter is just glued
to
place=
..
Thanks Krasw
Just got the drawings from Grob (linder). It does look like there
is a
barb=
ed fitting at the end of the TE socket, and it seem like that is
what has
b=
roken off based on the photo i took. Seems like having that
whole tube
repl=
aced by an A&P isn't going to too bad of a process, but who
knows, could
tu=
rn out to be a pain. Really don't want them to have to cut any
holes in
the=
skin or have to do any major composite work. Will chat with the
A&P and
co=
mposite shop about this.