On Sat, 11 Aug 2007 15:35:25 GMT, Larry Dighera
wrote:

I would assume that the source of these Li-ion Polymer battery fires
is excessive electrical current flowing through the battery either
from too high a charging rate, too high a discharge rate, or a short
internal (as in the case of the Sony laptop cells) or external, or
being over charged. Perhaps it would be prudent to install a circuit
breaker of fuse to prevent too high a current and a timer to
disconnect a forgotten charger.

I imagine the root of the problem is very low internal resistance
which, while making them very efficient, also allows the current to
"run away". Good circuit design can alleviate many of the issues, but
safety if the batteries are damaged in a crash is still an issue.

-Dana
--
--
If replying by email, please make the obvious changes.
-------------------------------------------------------------------------------
Abandon all hope, ye who PRESS ENTER here.