..Blueskies. wrote:
Anyone know any good sources for these.

It seems like I will be needing a nice repeatable one in the 5-100 in/lb range for 10-32 screws and nuts. I am not sure
what the torque is that I will be using, the screws are AN509-R10 (MS24694 #10) and the nuts are MS21040-3. I have seen
from 20 in/lbs to 60 in/lbs for these.


My personal ones are Snap-On's. All of ours at work are also Snap-On.
At 20 inchpounds, you are almost down to the point of needing to use
torque watches instead.

Craig