On Thursday, April 23, 2020 at 8:30:42 AM UTC-7, Jonathan St. Cloud wrote:
On Thursday, April 23, 2020 at 7:56:11 AM UTC-7, wrote:
On Thursday, April 23, 2020 at 9:10:51 AM UTC-4, Rob Cluxton wrote:
I apologize in advance if this has been discussed befo

My PowerFlarm core (LX9000) is picking up my Mode-S transponder as traffic about a mile out, same altitude. Any suggestions?

Thanks in advance,
Rob Cluxton
4D

Redo your configuration file.
UH

I am currently grounded, but my Alarm too is picking up my transponder and I have reconfigured several times to no avail. But I have not trouble shot beyond reloading config file.

Make sure you ICAC Mode S 6 digit code is correct in your PowerFlarm CFG. Check also all the other ADSB code lines for correctness. Try changing the code for PCAS range to 0 this turns off the PCAS.

Check your transponder for the correct ICAO code Mode S 6 digit code

Richard
www.craggyaero.com