FWIW, on the '75 Archer I used to own, the ammeter needle would sometimes stick
against the faceplate and not move. The mechanic bent the needle a little bit so
it wouldn't drag against the faceplate. The bent needle looked like crap, but it
worked after that.

Dave

Jeremy Lew wrote:
Ours is a '78 Warrior (PA-28-151/161).
According to our maintenance officer, the ALT warning light and zero ammeter
reading during low rpm (~1000) ground operations is actually not normal. It
did make me pause for a minute, but then I figured I was being paranoid
since I don't usually look at either of those indicators until the 2000 rpm
runup, when both of those indicators were normal.

We have a new alternator on order, I'll let you know what our outcome is
too.

Jeremy

"John Clonts" wrote in message
...

"Jeremy Lew" wrote in message
...

Was flying IFR in the clear on top of an overcast layer today. I

noticed

at

some point that the ammeter was indicating zero, and not moving. The

Alt

warning light was not illuminated, except when I pressed the test

button.

I

started to shut down non-essential electriconics in case this was for

real.

After a minute or two, the ammeter needle resumed normal indications,

and

stayed that way for the rest of the flight. The Alt warning light was
properly illumated during low-RPM operations on the ground, as well as
during the engine runup split switch check.

The warning light/ammeter needle discrepancy suggests to me that problem

was

in the ammeter, and that the alternator was functioning normally the

whole

time. Anyone have any theories as to what would cause indications like
this? Is external RF interference possible?


(x-posted to rec.aviation.owning)

What a coincidence, we've had the same sort of intermittent problem with

our

charging system on the last few flights! Of course, when we've had our
voltmeter there to diagnose it, it seems to work perfectly

Will let you know what we find-- please do likewise!

(Ours is a 1978 Cessna 210M - IO520).

Cheers,
John Clonts
Temple, Texas
N7NZ








--
Dave Butler, software engineer 919-392-4367