On Tuesday, December 20, 2016 at 5:25:16 PM UTC-8, RW wrote:
On Tuesday, December 20, 2016 at 7:48:11 PM UTC-5, Dan Marotta wrote:
Hi All,

I built a cable for My Power FLARM portable according to the drawing on
the Tech Tips portion of the ClearNav site but The CN does not connect
to the Flarm. I have a cable tester and the cable checks good. I've
tried baud rates from 19.2 to 57.6K and still no luck.

I also spoke with another CNII user at Moriarty and he asked me if I'd
enabled FLARM on my CNII. I've looked and can't find anything other
than Flarm Status - There is none, and Flarm Alerts and I have the
longest alerts selected.

What about the Flarm dataport strings? Flarm Only or Flarm and Nav
(I've tried it both ways without success)? Does anyone have any other
suggestions?

--
Dan, 5J

Power Flarm has to finish power up dance before you start CN.
Ryszard

Also the higher the baud rate, the longer the connection process. The CN2 starts looking at low rates then goes higher.
Jim