Tim

The colibri NMEA output should be GPGGA, GPRMC, LXWpx all YES, Baud
rate 4800, and make sure the infared port in off in the ipaq.

If this does not fix your problem, then I would look to the cabling
quite possibily a bad connection.

Richard
www.craggyaero.com




ttaylor at cc.usu.edu wrote:
I am running a system that includes WinPilot running on an Ipaq 37XX
series, Colibri GPS/logger and Borgelt B50. The system is very
unstable and will usually only run for an hour at the most and often
only a few minutes before it crashes or gives an error message.

I get a "lost GPS signal" quite often even though the colibri is
showing nine satellites and a 3D lock. Other times the Ipaq just
locks up and has to have the reset button pushed to get it running
again.

I have spoken to an other pilot with the same configuration and he is
having similar problems.

Has anyone dealt with this and found a solution or has any ideas of
what ot do to fix this?

Tim