On Jun 18, 5:45*am, Jim White wrote:
Look at the pipe cutter in the picture. No one in their right mind uses the
hull of their glider to place tools that they are using or have used. Sure
way to have a 'loose article' accident.

Judging by the picture the tube would appear to have been sensibly fitted
forward of the stick, between the pilots knees. I don't know about you
but I find it hard to fly my glider when sitting in front of the stick let
alone land it.

Jim

I'm not 100% familiar with the V2 innards, but it seems to me that the
photo was taken looking forward and that the relief tube was fitted
aft of the stick. I also can't tell whether it was an aftermarket job
or done at the factory. It looks like one of those "pipe-within-a-
pipe" deals that allows you to extend a rigid relief tube down into
the airstream far enough that your pee doesn't get all over the tail
boom, though the inner pipe wouldn't be depicted in this picture if
that's the design. If that was the intent, making the outer tube
flexible could make it hard to make the inner tube slide and peeing
directly into the outer tube that ends flush with the outside fuselage
shell might lead to having pee stream down the underside of the
glider. It's hard to tell from the picture, but that's what it looked
like. In any case installing a spear pointed up into the cockpit
seems like a good way to put your eye out, though the geometry of that
coming to pass would mean you'd have a whole lot of other things
really badly mangled already.

Maybe I'm not in my right mind, but the area under my seat pan is
flat, smooth an concave, so I generally put most of my tools, screws,
etc there then inspect that I take them all out before putting the pan
back in. Putting parts and tools on the ground is begging to lose them
or kick them around - but I don't generally have a nice shop to work
in so dirt and wind and such are bigger concerns for me, On my glider
you'd have to crack the seat pan to get it back in place on top of
something as big as a pipe cutter.

Tim, maybe you can explain the photo a tad more. And please confirm
for everyone that you have located the pipe cutter so we can stop
worrying. :-)

9B