On Fri, 29 Jun 2007 07:49:26 -0500, "Jim Burns"
wrote:

Both Rapco and Kelly Aerospace have break-in procedures on their websites.

If they are hydraulically operated disk brakes what reason could there
be for a break in? Even highly polished disks will roughen within a
day or two from moisture in the air and the pads should seat fully on
the disks with no special effort even if the disks are grooved.

Jim

"karl gruber" wrote in message
...
I just installed new break pads and am wondering if there is a procedure
to
brake them in?

Best,
Karl