hello,

I will begin the engine final assembly.
I read I need to begin with the 3 dowel screws and the front
two 7/16 through studs and low rear3/8 stud.
I don't find the tight order after that.

I guess it is better to tight all the stud nuts on big machined
washer before the sealant cure and fit the cylinders next
day.

I own and read the overhaul manual. If I don't find any order, I
will begin with center bearing, rear bearing next and remaining
front bearing nuts. At the end, all the flange bolts.


Thanks for any help
--
http://www.youtube.com/v/k6AP4SbRHNo...s=1&rel=0
Philippe Vessaire ҿӬ