Corky Scott wrote:

On Mon, 21 Jul 2003 16:28:37 GMT, Orval Fairbairn
wrote:

In article ,
(Corky Scott) wrote:

Good thing I like building airplanes so much or I'd think this is
really work.

Saturday and Sunday I decided to sand blast some parts and paint them.

One of the parts was the second valve cover for the 3.8L Ford V-6 (did
the other one last weekend). Painting the engine parts is easier than
doing any of the fuselage stuff because engine parts require the
special high temp paint and it comes in a spray can. All I have to do


Corky:

I hate to disillusion you, but the temperature specs for "engine enamel"
are the same as those for regular enamel.

I painted my cylinders, crankcase, etc. with PPG two-part, which is
great! All you have to do is wipe any oil off it -- it stays shiny and
chip-free after thre years.

You mean the spray cans that say "specifically designed for hot engine
surfaces" aren't any different from Krylon?

Geeze, another bubble burst.

Corky Scott

Wait a minute! I thought you switched to a Lycosaurus a while back.

Peter