On Monday, September 24, 2018 at 1:41:26 PM UTC-7, Valentin Mayamsin wrote:
I've recently purchased a used Cobra wing rigger. Though it doesn't seem to fit my Jantar Std 2 wings -- it's certainly made for wider wings. I'd like to offer it for sale and would like to identify its size and which wings it is designed for. All I know is the rigger cuff will go from 30 3/4 inches to 39 inches chord (780mm to 990mm). Please advise.

Thank you,
-Valentin

I've seen the glider type labeled on the wing cuff of Cobra riggers. The one I use with the 29 came with a 27, but was labeled ASH25 (molded into the lower surface of the main composite part).
We modified the leading edge of that one to work with thinner wings.
If the leading edge is the tricky bit, perhaps you can do the same to make it fit the Jantar?
Jim