View Single Post
  #8  
Old June 13th 18, 10:37 PM posted to rec.aviation.soaring
Bob Gibbons[_2_]
external usenet poster
 
Posts: 120
Default Feeding Two Devices from PowerFLARM

All of our club K-21 use a single PowerFlarm to drive both an original
Flarm LCD display (rear seat) and a LXNav FlarmLED display (front
seat). We use a PowerFLARM Y-Adapter, RJ45 to feed the front display.
Only one port is bi-directional (to the rear seat), but you say this
is not a concern for your application.

Bob

On Wed, 13 Jun 2018 08:55:13 -0700 (PDT),
wrote:

Yeah, I know this has been discussed. I've researched it. But I can't find this specific question answered.

I want to connect my PowerFLARM Portable to my LX FLARMView AND to my Kobo running TopHat. I don't think I need or can use a K6 Mux box: I'm not combining multiple inputs into a common output. It's the reverse: I want to use a single input to drive two outboard devices. I know there are other devices I can buy but I'm hoping it's really simple:

1. My PowerFLARM Portable has only one data port--an RJ45--vs. the two ports on the core--an RJ45 plus a DSub-9.
2. My FLARMView (rectangular model) has only one port--an RJ11--vs. the two such ports on the FLARMView 57 (round model)
3. I'm using an RJ45 cable to provide 12v to the PowerFLARM although I can also provide power via a separate dedicated power connector. I've also wired that cable to provide 5v to the Kobo and deliver the RX/TX wires to it from the PowerFLARM for GPS and FLARM target data.
4. Power and GPS/target data for the FLARMView are via a cable with an RJ45 connector on the PowerFLARM end and an RJ11 on the FLARMView end.
5. AFAIK, I'm not transmitting anything to the PowerFLARM from the Kobo/TopHat: i.e., no flight declarations, no MacCready settings. The same thing is true, I think, for the FLARMView: no downloads. To the best of my knowledge, all data moves in one direction only: from the PowerFLARM to the FLARMView and to the Kobo/TopHat (for GPS location and targets). Each of these set ups works fine: i.e., PowerFLARM connected to the Kobo/Top Hat and PowerFLARM connected to the FLARMView. But I have to pick one or the other now. I'd like to drive both devices at the same time.

So under this simplified case, can I simply connect the RJ45 ends of cables from the FLARMView and the Kobo into a dual-port adaptor and plug that into the back of the PowerFLARM, while providing power to the PowerFLARM via the separate connection?

Why, you ask? Well, I'm seeing some but not all of the FLARM target info displayed in Top Hat--the problem I posted about last year. So until I figure out a way to solve that problem, I'd like to have the small FLARMView display up at the same time as Top Hat is running on the Kobo.

Chip Bearden