Put a carburetor on the bench from a 180hp Lycoming and fill it with fuel.
Pump the
throttle(once) and watch the fuel hit the ceiling. You'll never pump the
throttle again when
the engine is hot!!! It's best just to go rich( a hot start, not fuel
injected) and crack the throttle,
crank a half a dozen blades, should start if engine is OK. I believe there
is more fuel thrown to the engine
with the throttle than the primer. Remember, the primer only adds fuel to
three of the cylinders and
not the fourth, so that helps on a hot start is one pump is needed from the
primer.

John Prince

From: "Nathan Young"
Subject: HOT start 180HP engine
Date: Monday, March 29, 2004 8:14 AM

On 28 Mar 2004 22:32:48 GMT, (Hankal) wrote:

My 1973 Skyhawk has the 360/180 hp engine carburated.
When the engine is hot it is difficult to start.
My procedure is master switch battery side on, fuel pump on. Prime throttle
3
times. Fuel pump off, turn starter while advancing the throttle.
Today she would not fire and the battery went south.

Master, fuel pump, no primer, mixture rich, crack throttle. Crank.

After 2 tries, if it will not start in this manner, then I assume it
is not longer 'hot' and prime regularly.

This is on a Cherokee 180... I believe it is easier to start than
most when hot.

-Nathan