? Screw head diameter?
Morgans wrote:
"jls" wrote
I know an A&P who bought all his screws for the rib-to-spar fasteners
and LE on a J-3 at the local hardware store. Does that mean he's loose
as a goose? Or looser?
I would have to believe that they do not meet specifications for repairing a
certified aircraft.
I might trust them for holding skin down, but not much more than that. No,
I take that back. I don't trust them that far.
Have you seen the quality of the hardware nuts and bolts and screws, lately?
Chinese steel is of such low quality, I would be surprised if it was 25% the
strength of a part to MilSpec part comparison.
No, I would not bet my life on the saving of a few bucks by using unknown
hardware screws. If I'm that short of cash, I will go fly model airplanes,
or something.
--
Jim in NC
You've got a point. I buy all my PK-type screws from ACS but even then
I get some I don't like. The CRS screws I have quit using because they
tend to break.
|