"Jerry Wass" wrote in message
...
In my Sproose catalog-2002 they are listed as round tie rods--right
under the
streamline tie rods---nearly as expensive too---then when you add
the end fittings
they really cost a bundle----get a little lathe, make your own out
of 1/4" 316
S.S. rod---grind a 3 or 4" section down to 3/16" to keep from
having a stress
riser area in the threads---or have the 1/4" rod roll-threaded to
5/16 ---make your own rod ends out of 7/16" or 1/2" hex rod---its
either money or time either way
you go.
Tom Mathes wrote:
Interesting, I suppose you make all your own rivetts as well?
--
..
--
Cheers,
Jonathan Lowe
whatever at antispam dot net
No email address given because of spam.
Antispam trap in place
Question Guys. In the Hatz wings the internal brace wire is
specified
as 3/16" AN703. Does anybody know a source for this? Spruce and
Wicks
do not specify.
Thanks,
Tom Mathes
|