"BTIZ" wrote in message
news:dTw8e.15021$%c1.1191@fed1read05...
lets see.. I would remember the 10 mile restriction in my brain (and on
my note pad) while flying direct to XYZ...

This leads to another question. Lets say I'm flying a 150 heading to XYZ. I
receive the instruction "Pass 10 miles N of XYZ at 10,000 ft". Does that
mean continue my present heading and 10 from XYZ be at 10,000 feet, or does
it mean find the waypoint that is 10 miles N on the 360 radial and pass that
point at 10,000 feet?


then direct to ABC... and then in
VOR (OBS) mode tune and fly the 131 radial outbound from ABC.... I'd also
check the charts to see if DEF is a "direct to" DEF.

Woudn't it have to be direct given a radial?


"Michael 182" wrote in message
...
Is there a simple way to program the Garmin to handle in-flight route
instructions such as :

"Pass 10 miles N of XYZ at 10,000 ft" or "Continue inbound to ABC, then
the 131 radial to DEF..."

I can make user waypoints, but it seems a little slow and awkward,
especially in hard IFR. Any tricks?

Thanks,

Michael