SN10b data to PNA?
On Sunday, November 10, 2013 12:14:03 PM UTC-5, wrote:
Looking for advice on how to send data from an ILEC SN10b to a pna
device such as an Avier/Gliderguider etc.
Thanks for any help.
Mark
Connect SN10 NMEA output (RS232) to PDA input.
SN10 NMEA output is also connected for example
to FLARM input for task declaration.
Do **NOT** connect PDA output to SN10 !!
Check SN10 option "PDA" to enable output.
NOTE: PDA must use proper RS232 levels or you will have a small fire.
Hope that helps,
Best Regards, Dave "YO electric"
|