I loaded a 300k declared triangle. The declaration
is there and the trace is there. The stats dropped
the start (thought I had an engine running in a Discus)
did not list the turnpoints, and indicated a start
when I finished, and then showed a photofinish 10 minutes
later and 10 miles away.

Downloading this flight through StrePla gave a proper
trace.

I was using a Volkslogger.

I have no clue!


At 07:42 21 July 2005, P. Corbett wrote:
Paul

For the record, I am using v2.4.

Load a flight where the stats are missing. Look in
the General Information
area at the top of the statistics page. Is the 'soaring
begin' time the same
as the 'soaring end' time? Is the duration zero or
possibly even negative?
This is what I see when my flight stats are missing.
Also, for me this
problem occurs about every 2nd or 3rd flight... some
are okay.

Could this be a logger issue?

Paul Corbett

'Paul M. Cordell' wrote in message
...
P. Corbett wrote:
Occasionally, a flight viewed with SeeYou will have
a normal General
Statistics section but will have a a blank Flight
Statistics section.
These flights were definitely logged because they
can be seen in both 2D
and 3D.

Here is a clue...each time this happens the General
Statistic section
shows that the times the flight started and ended
are the same and the
flight duration is therefore zero. I do not know if
this is a software
bug or an error I am making in setup or use.

I would appreciate any advice or thoughts on this
problem.

Thanks in advance,

Paul


I am having the same problem. A flight viewed in
V3.1 will show no
details in the Flight Statistics Phases. The same
flight viewed in v
2.4 will show all statistics. I posted this problem
on the SEE YOU
support forum on 4/8/05 and supplied flight logs.
Still no resolution.