At 05:04 23 July 2013, wrote:
Try going into AVIER Settings, System, Internal GPS,
Programs (Winpilot
gets its data from COM4 - LK8000 might be different),
Hardware (Probably
COM7 or COM8). If LK8000 has a COM Port setting it
probably should match
the Programs setting.


LK8000 has settings for COM port and baud rate. Go to
Config 2/LK8000 Setup/Device Setup (on version 4) or
Config(2)/Setup on earlier versions. Setup is on the
"Device configuration" screen. Match baud rate to the
supplying data source and COM port to whatever the
pin-out on the device connects to. This assumes the
cable also connects correctly.

If you are confident the cable is correct, trial and error
should sort it.

Alternatively why not ask for advice on the LK8000
forum: http://www.postfrontal.com/forum/default.asp?
CAT_ID=11