Thread: Inverted turn
View Single Post
  #3  
Old September 6th 04, 09:45 PM
Some
external usenet poster
 
Posts: n/a
Default

Dear Sir,
Thank you for the explanation, I am very glad you took the time to explain
it in such detail.

Best regards


"DSowder" wrote in message
...
If an aerobatic program dictates a 360 degree inverted turn to the

left....
will that be a left circle when viewed from the ground ie. right rudder

left
stick ? I tried to look it up in the "IAC Official Contest Rules" but I
can't seem to find it...


Neither....or either. The direction of turn is up to the pilot, as long as

he
ends up going the right direction. So you'd probably make the 360 in the
direction of the most open box, just to reduce the liklihood of going

"out".

Similarly, 90 and 270 degree turns from the X (main) axis to the Y axis

may be
made either way, so you choose based on other needs such as positioning

the
next figure, not going out, wind direction, etc.

90 and 270 turns FROM the Y axis TO the X axis must be made in whatever
direction results in your heading the correct direction once you're back

on the
X axis.

The Aresti symbols for rolls and spins are also non-directional. However,

if
there are consecutive roll symbols on a figure, they'll be either "same"

or
"opposite" and must be so flown. Spins and vertical (up or down) rolls

must
result in going the direction you want (or need) to go, and the "same" and
"opposite" concepts hold true also. Otherwise the symbols are

non-directional.

If there's a looping figure between rolls in a figure, for example a roll,

half
loop up, then half roll, the roll directions don't affect each other.

Similarly
a roll up on a hammer or humpty, and a roll down. Either can be made

either
direction, subject to the need to be going the right direction when you're
done.

Doug Sowder