On Monday, October 15, 2018 at 10:57:20 PM UTC-7, Ian wrote:
On 2018/10/16 01:54, Richard Pfiffner wrote:
Rolled on two coats of Duratec Vinyl ester surfacing primer, sanding tomorrow.
Pictures:
http://www.craggyaero.com/ventus.htm
Nicely documented project. I hope you don't get "arithmetic fatigue"
adding up all the hours.
Please advise the weight of the fuselage before you started verses that
when you finished. Also the moment arm balance for the rudder, before
and after. Be kind to the next owner and make sure it is fully
documented in the log books. This is always the "unknown" when looking
at a refinished glider.
Finish will be
PPG Shopline JP202 Surfacer and JAU Acrylic Urethane.
I used this on my wings 16 years ago. It was tied out at Siskiyou County Airport all summer for these years. Other than minor chips it held up amazingly well.
Richard
www.craggyaero.com
Richard
www.craggyaero.com