|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 28th 04, 02:45 PM
|
|||
|
|||
Burning out a Magneto Drop
I just received a booklet from TCM called "Tips on Engine Care" (a very
good book...available from TCM's website...http://www.tcmlink.com/). On page 12 it says "Never but never attempt to "burn out" a magneto drop with ground run-up. This 'time-honored' procedure succeeds only at the expense of the engine's mechanical health." Well, I was taught this time-honored way. What the book does not say is what you are supposed to do when you get roughness in one magento. Ideas? -Sami N2057M, Piper Turbo Arrow III 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Burning out the pitot heat? | Mitty | Instrument Flight Rules | 3 | December 30th 04 05:04 AM |
| Drop in and say hello | Gilan | Home Built | 0 | June 4th 04 05:12 PM |
| Economist: Let the dollar drop | Luca Morandini | Military Aviation | 5 | February 14th 04 05:58 PM |
| :-) let enola gay drop one more :-) | old hoodoo | Military Aviation | 3 | December 28th 03 05:39 PM |
| Ellery Queen and the Case of the Missing Magneto Gear Teeth | MikeremlaP | Owning | 3 | July 26th 03 03:01 AM |
Threaded Mode