|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 27th 15, 05:23 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFlarm Core and RS232
I'm confused about the RS232 feature with my PowerFlarm core.
The manual decribes the interface as RS232 but doesn't mention the voltage levels. Is it the voltage levels called out in the standard (-3 to -15, +3 to +15) or are these digital voltage levels (0, 5) with the RS232 protocol? I see some pilots with a DSub9/USB cable which will not give them the RS232 standard voltage levels. - TomR 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flarmview and Powerflarm Core Config File? | Papa3[_2_] | Soaring | 4 | May 18th 15 11:51 PM |
| PowerFLARM Core secondary FLARM antenna | [email protected] | Soaring | 27 | October 7th 14 02:53 PM |
| For Sale - Used PowerFLARM Core v1 | Paul Remde | Soaring | 1 | May 30th 14 04:09 AM |
| Powerflarm Brick/Core ADSB Range | Sean F (F2) | Soaring | 3 | September 5th 13 04:10 PM |
| PowerFLARM core external display software update | kirk.stant | Soaring | 5 | January 28th 13 09:56 PM |
Threaded Mode