|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 22nd 04, 08:57 PM
|
|||
|
|||
Remote Switch for Pointer ELT --- Why Does It Need Voltage?
The remote switch wiring diagram for the Pointer ELT shows a lead running to
the aircraft's 12V power supply. Why's that? The switch on the unit itself doesn't require a connection to the aircraft's power supply. TIA. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lycoming remote oil filter | Evan Carew | Home Built | 0 | November 5th 04 11:09 PM |
| Jim Weir - PTT switch article? | Corrie | Home Built | 2 | October 4th 04 05:46 PM |
| How to use Lycoming remote filter | Evan Carew | Home Built | 0 | October 1st 04 12:43 AM |
| REMOTE CONTROLLED AIRCRAFT | RCPLANE | Home Built | 0 | December 18th 03 07:40 PM |
| Fuel dump switch in homebuilt | Jay | Home Built | 36 | December 5th 03 03:21 AM |
Threaded Mode