|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 11th 06, 01:58 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Tensile Strength Question Continued
okay, got pounds per Square Inch and elongation differences and the failure
sequence in my noodle. For simplicity, let's use 120,000 and 80,000 psi numbers. So if the 120,000 # piece is .667 square inches and the 80,000# piece is 1.0 square inch,,,are the elongations the same??? Thanks, Dick 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| If I make it stronger | Jdandy | Home Built | 9 | August 30th 04 09:22 PM |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 06:03 AM |
| Why was the Fokker D VII A Good Plane? | Matthew G. Saroff | Military Aviation | 111 | May 4th 04 06:34 PM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 02:26 AM |
| Hinges under stress - mechanical engineering type question | Corrie | Home Built | 21 | August 6th 03 09:49 AM |
Threaded Mode