|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 31st 06, 06:40 PM
posted to rec.aviation.owning
|
|||
|
|||
Removing original equipment
Is there any reason I can't remove my factory OAT and throw it out? I
have a mechanical OAT gauge but would rather just use my EDM OAT gauge. The JPI says their gauge is only certified as "supplemental" but does the FAA even care if I have an OAT at all? I've been replacing the original OAT gauge every 2 years because it's mechanical and wears out (the needle starts to vibrate too much). -Robert 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UAV's and TFR's along the Mexico boarder | John Doe | Piloting | 145 | March 31st 06 06:58 PM |
| Breaking News.... (?) | john smith | Piloting | 1 | August 19th 05 02:13 AM |
| Equipment List Required Documentation | O. Sami Saydjari | Owning | 9 | April 21st 04 02:57 AM |
| Removing a Major Alteration. | JDupre5762 | Owning | 5 | March 19th 04 06:25 PM |
| Flying when you know there is something wrong with the plane | C J Campbell | Piloting | 26 | January 14th 04 04:38 PM |
Threaded Mode