|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 19th 07, 10:07 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
cad-plated stainless steel?
hi, guys,
I just ordered some stainless piano-hingepins (pn#03-49000). What Aircraft Spruce delivered were some cad-plated rods. I previously got some stainless and these were silvery-shiny. I complained at AS and they responded that their stainless 302 pins truely were cad-plated (?) I never heared about such. What should cad-plating of stainless be good for? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stainless steel exhaust | headwind | Home Built | 5 | February 14th 07 03:30 AM |
| nicopress sleeve for stainless steel cable | ls | Home Built | 3 | December 6th 05 04:09 PM |
| Working Stainless Steel | Bob Babcock | Home Built | 7 | February 14th 04 04:12 PM |
| OK, all you limeys: 4 beautiful chromium-plated valve covers for Continental O-200 | jls | Home Built | 5 | February 10th 04 05:36 PM |
| structural stainless steel tank screws needed for PA-32-300 | Dave | Owning | 11 | October 1st 03 10:14 PM |
Threaded Mode