|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 18th 07, 12:36 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Treating rust on tube interior?
I can twist and turn various tubular parts on my restoration project
and hear rust rolling down the tube. Assuming there is no serious corrosion, how is this treated? Does one make any attempt to remove rust from these sealed tubes or simply inject boiled linseed oil (etc.), slosh, drain? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rust prevention: Inside fuselage | Michael Horowitz | Home Built | 10 | August 20th 07 11:33 PM |
| Shaking off the Rust | john smith | Piloting | 22 | March 1st 07 01:36 AM |
| How is hurricane Frances treating you? | Gilan | Piloting | 4 | September 7th 04 06:16 AM |
| Heat treating 4130 | RAM | Home Built | 0 | July 18th 04 05:33 PM |
| Rust inhibitor? | Steve Thomas | Home Built | 10 | August 30th 03 10:34 PM |
Threaded Mode