|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 28th 07, 02:42 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Enlarging a bushing hole?
I find myself having to enlarge a bushing's ID by 1/16ths to 3/8ths.
My concern is I don't know how to insure the 3/8" bit is aligned with the axis of the hole. Centered is good, but I'm more concerned with the alignment. Suggestions? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Worm Hole no Need for Black Hole | Michael Baldwin, Bruce | Products | 2 | May 8th 07 12:04 PM |
| Jackson Hole TFR | [email protected] | Piloting | 24 | August 23rd 06 05:35 PM |
| Even during sentencing, this guy is an a*hole | H.P. | Piloting | 45 | March 15th 06 12:36 AM |
| Hole Finder | [email protected] | Home Built | 2 | March 6th 06 03:32 PM |
| Rubber Bushing Replacement | Boelkowj | Home Built | 8 | December 12th 03 01:45 AM |
Threaded Mode