|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 20th 07, 07:01 AM
posted to rec.aviation.piloting
|
|||
|
|||
Airmap 500 Navigation question
I was playing with my old Airmap 500 that has not actually seen any 'active'
service since I purchased it. Anyway, I entered a simple route A - B - C - D. When I select 'Navigate Route' , it would appear that it is trying to go directly to point D without going via A B & C. Is this normal or am I doing something wrong. Lost the manual by the way  B2Z 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question on AirMap® 600C | Bill Smith[_2_] | Piloting | 8 | March 8th 07 06:50 PM |
| LX Navigation | G.A. Seguin | Soaring | 6 | July 9th 04 06:32 AM |
| navigation question | mah | Military Aviation | 6 | February 25th 04 12:25 PM |
| Navigation question? | prashna | General Aviation | 1 | January 21st 04 11:06 AM |
| ADF/VOR navigation question | John Bell | Simulators | 0 | December 23rd 03 05:30 PM |
Threaded Mode