|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 18th 09, 03:07 AM
posted to rec.aviation.soaring
|
|||
|
|||
Cambridge Vario adjustment?
I have an LNav connected to a Model 20 GPS. The LNav has all the latest
updates. The Vario that is part of the LNav system shows about 1 kt up when sitting still. When the system is turned off, the vario settles back to zero. I have a Winter mechanical and it shows zero while this one shows up. Where can I adjust it to get to show zero right after start up? Thanks, Fred 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WTB: 57mm Cambridge Vario/FS: 80mm Cambridge Vario | ufmechanic | Soaring | 0 | March 24th 09 06:31 PM |
| PZL vario zero adjustment. | [email protected] | Soaring | 1 | September 29th 07 04:38 AM |
| Old Cambridge vario | Pupo Terso (Std. Austria) | Soaring | 3 | February 16th 06 08:53 PM |
| Old Cambridge Vario Wiring | Stewart Hamey | Soaring | 3 | November 11th 05 12:40 AM |
| Old Cambridge Vario Wiring | Stewart Hamey | Soaring | 0 | October 31st 05 01:08 AM |
Threaded Mode