|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 4th 09, 10:30 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Garmin 196 antenna inside fabric ?
Hello
Young friend of mine is finishing his EAA Biplane , he would like to mount the detector/antenna inside the fabric so as to not show on the outside of upper center section , the airplane is in the silver/aluminum stage of painting , the alum. powder in primer is used to block UV , he is wondering if it could also block the RF from the Sats., I told him that we might get an answer off the group. Thanks Phil L. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Antenna under fabric in welded tube ship? | Jon[_6_] | Home Built | 7 | April 27th 08 07:50 PM |
| Garmin GA56 GPS antenna | [email protected] | Home Built | 1 | September 12th 07 03:31 AM |
| antenna for Garmin GPS in C172 or C152 | d&tm | Piloting | 7 | May 8th 07 03:12 AM |
| Garmin 95 antenna needed | Marty from Florida | Owning | 0 | February 19th 06 09:48 PM |
| Garmin remote antenna | Dave | Piloting | 3 | December 18th 05 12:58 PM |
Threaded Mode