|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 19th 09, 08:40 PM
posted to rec.aviation.soaring
|
|||
|
|||
Alternative to welding aluminum frame of Komet?
I just noticed that a few of the welds on the top aluminum framework
of my Komet trailer have broken. Maybe I am just lazy but I am concerned about getting the welds redone with the fiberglass top right next to it. Does anyone have any suggestions for a good bonding agent to use on the broken welds? Thanks, Bruno - B4 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gas Welding Aid 1 - welding clamp 1.JPG (0/1) | Stealth Pilot[_2_] | Aviation Photos | 1 | March 26th 09 08:20 AM |
| gas welding aid 2 - welding clamp 2.JPG (1/1) | Stealth Pilot[_2_] | Aviation Photos | 0 | March 26th 09 04:58 AM |
| gas welding aid 2 - welding clamp 2.JPG (0/1) | Stealth Pilot[_2_] | Aviation Photos | 0 | March 26th 09 04:57 AM |
| aluminum rib, aluminum spar, holes drilled but screws broken off | jls | Home Built | 13 | January 3rd 07 09:06 AM |
| Aluminum welding | Ernest Christley | Home Built | 5 | April 24th 06 12:47 PM |
Threaded Mode