|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 19th 10, 03:53 PM
posted to rec.aviation.soaring
|
|||
|
|||
CAI302 bent control knob
The control knob on my Cambridge 302 is slightly bent. It rotates OK
but will not "double click" - it sticks when pushed in and has to be pulled out. Is it safe to try to bend it straight? Any advice on the best way to do this? Walter 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CAI302 altitude in NMEA.. | PCool | Soaring | 6 | October 23rd 09 08:25 PM |
| Scraped - not bent - | Dave Kearton | Aviation Photos | 6 | April 7th 08 03:09 AM |
| Wrench size for KI214 & KI201 OBS knob | Roy Page | Owning | 7 | March 11th 05 11:07 PM |
| Narco MK12D MHZ Knob Set Screw Needed | NW_PILOT | Owning | 0 | May 21st 04 07:25 AM |
| You Want Control? You Can't Handle Control! -- Was 140 dead | ArtKramr | Military Aviation | 0 | March 2nd 04 09:48 PM |
Threaded Mode