|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 8th 04, 05:11 PM
|
|||
|
|||
wiring a mic plug
Picked up an old headset in an aerojumble. The headphones are ok, The mic
does not work because the mic plug was removed. I was wondering how one wires up the mic plug. I just happen to have a pj068 about. The mic cable has an inner cable with a screen outside of it, There are three possible connecting places on the pj068. Just wondering how I should connect it. BTW the headset is a Telex E951. Thanks sg 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Helicopter headset plug - help needed | NewsGroups | Home Built | 4 | September 8th 04 06:21 PM |
| Plug in voltmeter | Bob | Owning | 12 | December 27th 03 02:00 PM |
| WTB: Turbine ignition exciter unit, single plug | Juan E Jimenez | Aviation Marketplace | 0 | August 25th 03 01:48 AM |
| wiring diagram requests | Rick Pellicciotti | Home Built | 2 | August 5th 03 03:39 PM |
| Kawasaki TA-440 2B wiring diagram. | jackthepilot | Home Built | 1 | August 4th 03 07:33 PM |
Threaded Mode