|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 7th 15, 04:02 AM
posted to rec.aviation.soaring
|
|||
|
|||
O-ring material for DOT-3 fluid
Just got a new Cleveland caliper assembly for one of our club's G-103's. Grob requires the use of DOT-3 fluid because of the master cylinder. The o-ring in the piston is designed for 5056 fluid. I'm told DOT-3 will call that o-ring to swell. So we need to replace the o-ring.
Does anyone know what common o-ring materials are compatable with DOT-3? Aircraft Spruce, BTW, doesn't sell DOT-3 compatable o-rings. Thanks, Larry 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluid Power Ohio | nimbus | Soaring | 5 | February 24th 09 12:47 PM |
| Pitts brake fluid | Al MacDonald | Aerobatics | 2 | April 25th 05 04:43 AM |
| BRAKE FLUID | Ventus B | Soaring | 9 | October 17th 04 08:25 PM |
| compass fluid | D.A.L | Soaring | 4 | September 20th 03 04:06 PM |
| Need help with Fluid Mechanics equation | Doug | Home Built | 4 | August 16th 03 04:13 AM |
Threaded Mode