![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Was reading an article by Mike Borgelt that when flying through a thermal you will not circle in you should just fly the STF.
I have always slowed in such thermals, sometimes slowing to thermal speed while putting the thermal flaps. I do try to accelerate before I leave the lift. My thought being try to stay in the lift as long as possible while still moving forward, sometimes even s-turning to stay in large thermal but still moving down the course line. Would appreciate any comments, critique, thoughts... |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
MH-65 Dolphin - Airframe Recovery - 5 | Tom[_8_] | Aviation Photos | 0 | May 6th 10 06:05 PM |
MH-65 Dolphin - Airframe Recovery - 3 | Tom[_8_] | Aviation Photos | 0 | May 6th 10 06:05 PM |
MH-65 Dolphin - Airframe Recovery - 2 | Tom[_8_] | Aviation Photos | 0 | May 6th 10 06:05 PM |
HH-65 Dolphin Helicoper Cockpit.jpg (1/1) | J.F. | Aviation Photos | 0 | September 7th 07 02:47 PM |
Fly Argentina - Douglas Dolphin.jpg (1/1) | Mitchell Holman | Aviation Photos | 0 | December 9th 06 02:25 AM |